the string is already assembled on the rail saver. Simply pass it through the plug and then pull and re-lock on the rail saver using the rip tab. The rail saver is now correctly positioned and ready for use.
WARNING : never hold your board with your hands or fingers wrapped in the cord. This can lead to serious finger injury.
Our leashes are tested under tensile strengths higher than the forces found during use on a surfboard. However, always check the condition of your leash before going into the water. Micro-cuts can affect its resistance. Regularly change your leash, especially if your board remains in the sun for long periods of time.
This prevents the leash from getting twisted up in the water.
To avoid deforming the cord, which can cause it to twist up in the water.
Protects the rail of your board from being cut by the leash rubbing against the edge.